Husqvarna FE 450 2016 Repair Manual page 161

Stand the vehicle upright.
O
Remove screw cap with membrane
Press the brake caliper onto the brake disc by hand in order
to push back the brake piston and ensure that brake fluid
does not flow out of the brake fluid reservoir, extracting it by
suction if it does.
Info
Make sure when pushing back the brake piston that
you do not press the brake caliper against the spokes.
Remove cotter pins @), pull out pin
brake linings.
Clean the brake caliper and brake caliper support.
0
Check that leaf spring in the brake caliper and sliding
(D
plate in the brake caliper support are seated correctly.
✓ The arrow on the leaf spring points in the rotation direc­
tion of the brake disc.
Insert the new brake linings, insert pin
pins@).
• Info
I
Always change the brake linings in pairs.
Make sure that decoupling plate @ is mounted on
the piston side brake lining.
Operate the foot brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point.
16 BRAKE SYSTEM
8
and the 0-ring.
C,,
and remove the
C,,
and mount cotter
159