Installing The Clutch Cover; Installing The Water Pump Cover - Husqvarna FE 450 2016 Repair Manual

18 ENGINE
18.5.19
18.5.20
238

Installing the clutch cover

Installing the water pump cover

-
Position the balancer shaft with special tool
I Marking mandrel (78129032000)
f)
✓ Marking and the special tool are aligned.
8.
-
Mount dowels Put the new clutch cover gasket
place.
-
Mount the clutch cover.
8
-
Mount screws and tighten once all of the clutch cover
screws have been mounted.
Guideline
I I
Screw, clutch cover
0
-
Mount screw and tighten once all of the clutch cover
screws have been mounted.
Guideline
I I
Screw, clutch cover
(D
-
Mount screw and tighten all screws in a crisscross pat­
tern.
Guideline
I I
Screw, clutch cover
-
Remove the special tool.
I Marking mandrel (78129032000)
-
Put the water pump cover seal in place.
-
Mount the water pump cover. Mount screw
ing washer but to not tighten yet.
Guideline
Screw, water pump
cover
8
-
Mount screw but do not tighten yet.
O.
(a p. 362)
CD
1 10
M6x25 Nm (7.4 lbf ft)
1 10
M6x55 Nm (7.4 lbf ft)
M6x30 1 10 Nm (7.4 lbf ft)
(� p. 362)
O
with the seal-
10
M6x25 Nm (7.4 lbf ft)
in