Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
6.9
i
I!
Ii
20
Removing the fork �rotector
Installing the fork �rotector
Performing a fork service
800462-01
O
-
Remove screws
and take
8
-
Remove screws
on the left fork leg and take
fork protector.
-
Remove screws (D on the right fork leg and take
fork protector.
-
Position the fork protector on the left fork leg. Mount and
O.
tighten screws
Guideline
Remaining screws,
chassis
-
Position the brake line, wiring harness, and clamp. Mount and
8.
tighten screws
-
Position the fork protector on the right fork leg. Mount and
tighten screws (D .
Guideline
Remaining screws,
chassis
Condition
The fork legs have been removed.
-
Disassemble the fork legs.
-
Remove the spring.
(a
p. 23)
-
Disassemble the cartridge.
-
Disassemble the piston rod.
-
Disassemble the hydrostop unit.
-
Disassemble the seal ring retainer.
-
Check the fork legs.
(IUI
p. 27)
-
Assemble the seal ring retainer.
-
Assemble the hydrostop unit.
Assemble the piston rod.
-
Assemble the cartridge.
Assemble the fork legs.
(0
the clamp.
off
the left
off
off
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
(a
p. 21)
(a
p. 24)
(!l.,!
p. 25)
(!l.,!
p. 26)
(!l.,!
p. 27)
(IUI
p. 29)
(IUI
p. 29)
(IUI
p. 30)
(IUI
p. 31)
p. 33)
the right
..
..
..
Advertisement
Table of Contents
