Husqvarna FE 450 2016 Repair Manual page 104

12 FUEL TANK, SEAT, TRIM
102
-· -
,
. .. ... .'.a.
.
..
(FE EU/AU)
Position the collar bushings and horn, and mount and
8.
tighten screws
Guideline
Remaining screws,
chassis
Connect the connector of the horn.
(FE 450/501 US)
Position the collar bushings, and mount and tighten
screws @ .
Guideline
Remaining screws,
chassis
(FE 501 SUS)
Position the collar bushings and horn, and mount and
tighten screws @ .
Guideline
Remaining screws,
chassis
Connect the connector of the horn.
@)
Plug in connector for the fuel pump.
Remove the wash cap set.
-
Thoroughly clean the plug-in connection of the fuel line using
compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
Lubricate the O-ring and connect plug-in connection
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
Mount the seat. (I!,) p. 98)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
C,
for
..