Husqvarna FE 450 2016 Repair Manual page 38

6 FORK, TRIPLE CLAMP
36
-
Pull out the piston rod and push it back in numerous times
while pressing it to one side slightly.
✓ Air bubbles emerge and the cartridge is bled.
-
Keep bleeding until no more air bubbles emerge.
✓ The piston rod automatically moves out to the center of
the full stroke.
Info
When fully bled, the correct air chamber length is
202090-10
achieved.
-
Position the spring.
-
Pull the spring downward. Mount screw cap@).
Info
When assembling, ensure that the screw caps are cor­
rectly mounted according to the hydrostop needles.
Rebound damping side - red hydrostop needle, screw
cap with mark REB.
Compression damping side - silver hydrostop needle,
screw cap with mark COMP.
-
Mount the open end wrench on the hexagonal part.
-
Hold the open end wrench. Tighten screw cap @).
Guideline
Screw cap on piston
rod
I Mounting tool (T1404 7)
-
Push the outer tube upward.
-
Clamp the outer tube in the area of the lower triple clamp.
I Clamping stand (T1403S)
-
Tighten screw cap@).
Guideline
Cartridge on outer
tube
201701-11
I Mounting tool (T1404 7)
-
Mount the adjuster.
-
Mount and tighten screw@).
Guideline
I Screw, adjuster
201700-11
M8x0.75 18 Nm (13.3 lbf ft)
(a p. 367)
(a p. 367)
M51x1.5 40 Nm (29.5 lbf ft)
(a p. 367)
I I
M4x0.5 2.5 Nm (1.84 lbf ft)