Table of Contents
Advertisement
-
Check grooved ball bearing
If the grooved ball bearing does not move easily or is worn:
-
Change the grooved ball bearing.
8
-
Check shift rollers
for surface damage and cracking.
If the shift roller exhibits surface damage or cracking:
-
Change the shift drum.
0
-
Check springs
of the shift rails for damage and wear.
If the spring is damaged or worn:
-
Change the spring of the shift rail.
-
Check shift rails (D on a flat surface for run-out.
If there is run-out:
-
Change the shift rail.
-
Check the shift rails for scoring, seizure marks, and stiffness in the shift fork.
If the shift rail has scoring, seizure marks, or does not move easily in the shift fork:
-
Change the shift rail.
-
Check sliding plate@ for wear on contact areas(!).
If the sliding plate is worn:
-
Change the sliding plate.
0
-
Check return surface
If there is severe grooving:
-
Change the sliding plate.
-
Check guide bolts @ for firm seating and wear.
If the guide bolts are loose or worn:
-
Change the sliding plate.
-
Preassemble the shift shaft.
18.4.36
Preassembling the shift shaft
CD
for smooth operation and wear.
on the sliding plate for wear.
(l!!JJ
p. 221)
-
Check clearance 4) between the sliding plate and the shift
quadrant.
Shift shaft - play in sliding
plate/shift quadrant
If the measured value does not meet specifications:
-
Change the sliding plate.
304682-10
-
Secure the short end of the shift shaft in the bench vise.
I
Guideline
Use soft jaws.
-
Mount sliding plate
and put the guide pin on the shift quadrant.
-
Mount pressure spring
-
Slide on spring guide
offset end facing upward, over the spring guide and lift the
304683-10
offset end over abutment bolt
-
Mount stop disk (D.
0.40 ... 0.80 mm (0.0157 ...
0.0315 in)
O
with the guide pin facing downward
8.
e,
CD,
push return spring
0.
18 ENGINE
with the
221
Advertisement
Table of Contents
