Filling Damper With Nitrogen - Husqvarna FE 450 2016 Repair Manual

9.25

Filling damper with nitrogen

9 SHOCK ABSORBER, SWINGARM
Info
The floating piston must be positioned at exactly
this point when the rod is fully extended; otherwise,
damage will occur during compression of the shock
absorber.
-
Remove the special tool.
O
-
Remove adapter from connection
pump.
• Info
I
Hold the damper so that the filling port is at the high­
est point.
-
Remove the adapter.
Mount and tighten screw
Guideline
I
Screw, filling port I M10x1
O
-
Mount screw with the O-ring and screw it in approx. 2 full
turns, but do not tighten it fully yet.
Info
The piston rod is fully extended.
-
Fix the special tool in the vise.
I
Filling tool (T170S1) (�
-
Connect the special tool to the pressure regulator of the filling
cylinder.
I
Filling gas - nitrogen
-
Adjust the pressure regulator.
Guideline
I
Gas pressure
-
Position the damper in the special tool.
✓ The hexagonal part of tap handle
hexagon socket of the filling port screw.
-
Open filler tap Ci).
-
Fill the damper for at least 15 seconds.
Guideline
I
Gas pressure
8
of the vacuum
0.
14 Nm (10.3 lbf ft)
p. 369)
11 0 bar (145 psi)
f)
engages in the
11 0 bar (145 psi)
75