Table of Contents
Advertisement
202480-11
Assemblin the fork le s
Info
When assembling, ensure that the right cartridge is mounted in the corresponding inner tube and the
right adjuster is mounted on the corresponding screw cap.
Compression damping side - screw cap with mark
Rebound damping side - screw cap with mark
B
/
-8
:-------8
R00037-10
fD
-
Clamp piston rod
with the special tool.
I
Clamping stand (T14049S)
-
Mount spring guide Gi) all the way on.
Info
The nut must be firmly tightened against the stop by
hand. Do not use a tool.
48.
-
Mount adjusting tube
-
Unclamp the piston rod. Mount the preload spacer(s).
COMP,
brake caliper holder, white adjuster.
no brake caliper holder, red adjuster.
REB,
Preparatory work
-
Assemble the hydrostop unit.
Main work
-
Clamp the inner tube with the axle clamp.
I
Guideline
Use soft jaws.
-
Mount the special tool.
I
Protecting sleeve (T1401)
-
Grease and push on dust boot
I
Lubricant (T14034)
(a
p. 350)
Info
Always change the dust boot, seal ring, lock ring, and
support ring.
Mount the sealing lip with the spring expander facing
down.
-
Push on lock ring @.
-
Grease and push on seal ring (D.
I
Lubricant (T14034)
(I!!.:!
p. 350)
•
Info
I
Sealing lip downward, open side upward.
C,.
-
Push on support ring
-
Remove the special tool.
6 FORK, TRIPLE CLAMP
(I!!.:!
p. 368)
(I!!.:!
p. 29)
(a
p. 367)
O.
33
Advertisement
Table of Contents
