Configure And Display Lan Settings - HP Visualize c100 Service Handbook

Boot Console Interface Model C100/110
Configure and Display LAN Settings
The LanConfig command configures and displays the
current LAN settings. The C180, C200 and C240 sys-
tems support 10Base-T, 100Base-T and AUI stan-
dards.
To automatically select the network speed (100 Mbits/sec or
10 Mbits/sec) and data transfer operation (full or half
, operating in compliance with IEEE 802.3u
duplex)
type the following at the prompt:
Configuration Menu: Enter command
LanConfig AUTO_detect
>
To select 10 Mbits/sec network speed and half duplex mode,
type the following at the prompt:
Configuration Menu: Enter command
LanConfig 10/Half_dx
>
To select 10 Mbits/sec network speed and full duplex mode,
type the following at the prompt:
Configuration Menu: Enter command
LanConfig 10/Full_dx
>
To select 100 Mbits/sec network speed and half duplex
mode, type the following at the prompt:
Configuration Menu: Enter command
LanConfig 100/Half_dx
>
To select 100 Mbits/sec network speed and full duplex
mode, type the following at the prompt:
Configure and Display LAN Settings
,
207