HP Visualize c100 Service Handbook page 124

Troubleshooting
Running System Verification Tests
6 To verify the system operation, type the following at
the CSTM> prompt:
Messages similar to the following appear:
Verification has started on device (CPU).
Verification has started on device (FPU).
CSTM>Verification of (FPU) has completed.
CSTM>Verification of (CPU) has completed.
7 When you see the >> prompt, enter r. The following
messages and graphics test window appear:
Verification of (2/0/1.0.0) has completed.
Verification of (2/0/1.5.0) has completed.
Verification of (2/0/1.6.0) has completed.
Verification of (CPU) has completed.
Verification of (FPU) has completed.
Verification of (2/0/2) has completed.
Verification of (0/0/0) has completed.
8 Press ENTER to return to the CSTM> prompt after all
test results are reported.
9 To exit the Support Tools Manager, enter the following:
If any tests failed, run Self Test and ISL diagnostics to
isolate the problem.
96
verify all
Result status - (Success)
Result status - (Success)
Result status - (Success)
Result status - (Success)
Result status - (Success)
Result status - (Success)
Result status - (Success)
exit