Configure And Display Lan Settings (B132L+/B180L Only) - HP Visualize b132L Service Handbook

Configure and Display LAN Settings (B132L+/B180L Only)
Configure and Display LAN Settings
(B132L+/B180L Only)
The LanConfig command configures and displays the
current LAN settings. The hardware system supports
10Base-T, 100Base-T and AUI standards.
To automatically select the network speed (100 Mbits/sec or
10 Mbits/sec) and data transfer operation (full or half
duplex), operating in compliance with IEEE 802.3u, (this is
the default and recommended setting) type the following at
the prompt:
Configuration Menu: Enter command
LanConfig AUTO
>
To select 10 Mbits/sec network speed and half duplex mode,
type the following at the prompt:
Configuration Menu: Enter command
LanConfig 10/Half_dx
>
To select 10 Mbits/sec network speed and full duplex mode,
type the following at the prompt:
Configuration Menu: Enter command
LanConfig 10/Full_dx
>
To select 100 Mbits/sec network speed and half duplex
mode, type the following at the prompt:
Configuration Menu: Enter command
LanConfig 100/Half_dx
>
To select 100 Mbits/sec network speed and full duplex
mode, type the following at the prompt:
Boot Console Interface
207