Installing An Eisa Slot Blank Plate - HP Visualize c100 Service Handbook

NOTICE: If you are not replacing the board, perform the
following procedure:
1 Install a blank plate in the rear panel, as shown in
2 Install the EISA retainer, as shown in Figure 47.
3 On the blank plate, turn the locking knob clockwise to
4 Perform Steps 3 through 1 in reverse order.
Figure 47

Installing an EISA Slot Blank Plate

FRU Removal and Replacement
Figure 47
secure blank plate, as shown in Figure 47.
Field Replaceable Units
135