HP Visualize c100 Service Handbook page 255

Boot Console Interface Model C160L/160/180/200/240/360
To set a system path to a new value, follow the direc-
tions in "Accessing the Boot Console Interface" ear-
lier in this chapter, and then type the following at the
prompt:
Main Menu: Enter command >
where path_type is one of the path types listed in Table
25 and path is the specification of the path in Mne-
monic Style Notation (as described in Table 26). For
example, to set the primary boot path to a scsi disk
with an ID of 6.0, follow the directions in "Accessing
the Boot Console Interface" earlier in this appendix,
and then type the following at the prompt:
Main Menu: Enter command >
Displaying and Setting Paths
path path_type path
path pri sescsi.6.0
227