Setting The Module Time - WAGO 765-1505/100-000 Product Manual

Commissioning
ð If the method call was unsuccessful, then "−1" appears under Status.
Description of the Input Arguments
Input Arguments
Force ID
Description of the Output Arguments
Output Arguments
Status and Message

10.3.3.2 Setting the Module Time

The module has an integrated clock that retrieves the time from an NTP server via NTP
(Network Time Protocol). To do so, the module needs the IP address of the NTP server.
An OPC UA client is necessary in order to set the IP address of the NTP server.
The nodes of the OPC UA server for configuring the NTP client are described in
Client Configuration
100 Product manual | Version: 2.0.0
8DIO FLD EI DC 24V 2.0A
Table 62: Input Arguments of the DisableForcing Method
Description
Here the OPC UA client must use the Force ID that the
OPC UA client had received after the GetForcingID
method was called.
Table 63: Output Arguments of the DisableForcing Method
Description
0: Forcing IO-Link successful
−1: Forcing IO-Link failed
[} 83].
765-1505/100-000
Figure 38: DisableForcing Method
8 NTP