Adjusting The Gas Nozzle Clamping Device On The Robacta Reamer Alu Edition And Robacta Reamer Alu 3000Upm; Adjusting The Gas Nozzle Clamping Device - Fronius Robacta Reamer Alu Edition Manual

Adjusting the gas nozzle clamping device on the Ro-
bacta Reamer Alu Edition and Robacta Reamer Alu
3000upm
Adjusting the gas
NOTE!
nozzle clamping
device
The gas nozzle clamping device must be adjusted so that no bearing pressure is
transferred to the robot.
The gas nozzle must only be clamped onto the cylindrical surface.
4
NOTE!
The gas nozzle must be clamped centrally over the cleaning motor.
Tighten Allen screws on the guide bolts (1) and (2)
Loosen Allen screws on the guide bolts
1
(1) and (2)
Move the welding torch to the cleaning
2
position
- centrally with respect to the clea-
ning motor
Using the adjusting screw (3), position
3
the clamping device (4) so that the
(1)
clamping device is on the gas nozzle
(3)
(2)
(4)
41