Adjust Gas Nozzle Clamping Device; Adjusting The Gas Nozzle Clamping Device - Fronius Robacta Reamer V Easy Operating Instructions/Spare Parts List

Adjust gas nozzle clamping device

Adjusting the gas
nozzle clamping
device
Robacta Reamer V Easy Han6P J only:
risk of damage to the cleaning device and the welding torch if the gas nozzle clamp-
ing device is not properly adjusted.
► The gas nozzle clamping device must not be altered when using gas nozzles with an
► When using gas nozzles with an outer diameter greater/less than 25 mm (0.98 inch),
NOTE!
The gas nozzle clamping device is adjusted in the same way on the Robacta Reamer
V Easy and the Robacta Reamer V.
4
5
NOTE!
Only clamp the gas nozzle centrally above the cleaning motor.
CAUTION!
outer diameter of 25 mm (0.98 inch) - the gas nozzle clamping device has already been
adjusted for use with gas nozzles with an outer diameter of 25 mm (0.98 inch) at the
factory.
the gas nozzle clamping device must be adjusted before using it for the first time and
each time a device is replaced.
Tighten the Allen screws on the guide bolts (1) and (2)
Robacta Reamer V only:
Move and check the TCP tip
NOTE!
Adjust the clamping device in such a
way that no reaction forces can be trans-
ferred to the robot.
The gas nozzle must only be clamped onto
the cylindrical surface.
(1)
(3)
Loosen the Allen screws on the guide
1
(2)
bolts (1) and (2)
(4)
Move the welding torch to the cleaning
2
position
- centrally with respect to the clea-
ning motor
Using the adjusting screw (3), position
3
the clamping device (4) so that the
clamping device is on the gas nozzle
47