Gauges And Cdm Display; Engine Speed - MacDon M150 Assembly Instructions Manual

4. Glow plug light on CDM will cycle on/off/on
after 2 seconds for a pre-set length of time.
The operating period for the glow plug light
will change depending engine temperature.
CAUTION
Check to be sure all bystanders have cleared
the area.
5. When glow plug light goes out, turn key to
START and crank engine until it starts.
Leave throttle at IDLE.
IMPORTANT
If engine fails to start within 30
seconds, cease cranking and wait two
minutes to allow the starting motor to
cool before attempting to re-start the
engine.
6. If engine fails to start, repeat steps 1 to 4.
7. Engine will cycle through a period where it
appears to labour.
M150 – CUMMINS ENGINE
1. Follow procedure for Normal Start.
2. Engine will cycle through a period where it
appears to labour until engine warms up.
NOTE
Throttle is non-responsive during this
time as engine is in "WARM UP"
mode. This mode will last from 30
GROUND SPEED
mph or kph
ENGINE RPM
ENGINE WARNING LIGHTS
Engine Pre-Heat/Water In
Fuel/Do not Operate/Stop Engine
IGNITION SWITCH POSITIONS
Accessory/Stop/Run/Start
Form # 169018
PRE-DELIVERY CHECKS
DISPLAY
Engine/Tractor Functions
seconds to 3 minutes depending on
temperature.
stabilized and idling normally, throttle
becomes active.
Do not operate engine above 1500
rpm until engine temperature gauge is
above 100°F.
III. GAUGES AND CDM DISPLAY
a. Check engine temperature gauge and fuel
gauge are working.
b. Check CDM display is working by pushing
SELECT on CDM or SELECT button on GSL.
IV. ENGINE SPEED
a. Check engine rpm on CDM.
M150
M200
HAZARD WARNING LIGHTS SWITCH
Activates Hazard Warning Flashers
Cancels Turn Signal
Allows Operator To Select Display Item
On Lower Line.
Push To Select
TURN SIGNAL SWITCHES
Activates Turn Signals On Tractor and Header
Engine Forward Mode Only
Push-On/Push-Off
40
After engine
IMPORTANT
IDLE MAX RPM (No Load)
1100 2270-2330
1100 2250-2300
SELECT SWITCH
Model Year - 2009
has