MacDon M150 Assembly Instructions Manual page 40

3. Insert a wood block approximately ¾ inch
(19 mm) thick between the other channel
and pintle arm so that the interlock channel
is clear of the pintle arm.
4. Turn the steering wheel off center, and
move the GSL in N-DETENT.
5. Try to start the engine. The CDM will flash
"CENTER STEERING", accompanied by a
short beep with each flash, and the engine
should not turn over.
over, the system requires adjustment. See
your dealer.
6. Remove key.
7. Remove wood block inserted at step 3
above and close hood.
CAUTION
Check to be sure all bystanders have cleared
the area.
c. With the engine shut down, steering wheel
centered, and the GSL in Neutral but not in N-
DETENT;
1. Try to start the engine. The CDM will flash
"CENTER STEERING" on the upper line,
and "PLACE GSL INTO N" on the lower line
accompanied by a short beep with each
flash, and the engine should not turn over. If
the engine turns over, the system requires
adjustment. See your dealer.
Form # 169018
PRE-DELIVERY CHECKS
If the engine turns
38 Model Year - 2009