Step 12. Perform Pre-Delivery Checks; Final Drive Lubricant Level; Tire Pressures; Engine Coolant - MacDon M150 Assembly Instructions Manual

STEP 12. PERFORM PRE-
DELIVERY CHECKS
WARNING
Stop windrower tractor engine and remove
key before making adjustments to machine.
A child or even a pet could engage the drive.
a. Perform the final checks and adjustments as
listed on the "Pre-Delivery Checklist" (yellow
sheet) to ensure the machine is field-ready.
Refer to the following pages for detailed
instructions as indicated on the checklist.
b. The completed checklist should be retained
either by the operator or the dealer.
A. FINAL DRIVE LUBRICANT LEVEL
OIL LEVEL
WHEEL CONFIGURATION A
OIL LEVEL
WHEEL CONFIGURATION B
c. Rotate wheel so that one of the plugs is
horizontally aligned with the center of the hub.
d. Remove the plug.
through the hole or slightly running out.
Form # 169018
PRE-DELIVERY CHECKS
The oil should be visible
B. TIRE PRESSURES
Measure tire pressure with a gauge.
Bar – 32 psi (221 kPa)
Turf – 20 psi (138 kPa)
Caster - 10 psi (69 kPa)
C. ENGINE COOLANT
a. Check daily the coolant level in the coolant
recovery tank. Tank should be at least half full.
b. Check coolant concentration in the radiator.
Coolant shall be good for temperatures of -30°F
(-34°C).
D. AIR CLEANER
a. Check that air cleaner cap is firmly attached and
that all clamps are secure.
b. Check spring clamp at back of air cleaner.
35
HOLD 0.018 in. (0.46 mm)
GAUGE BETWEEN MIDDLE
COILS & TIGHTEN CLAMP
UNTIL GAUGE IS SNUG.
Model Year - 2009