Gear Box Lubricant Level; A/C Compressor Belt; Perform Safety System Checks - MacDon M150 Assembly Instructions Manual

G. GEAR BOX LUBRICANT LEVEL
a. Remove plug. The lubricant should be visible
through the hole or slightly running out.
b. Replace plug and tighten.
H. A/C COMPRESSOR BELT
a. Tension on A/C compressor belt should be such
that a force of 8 to 12 lbf (35-55 N) deflects the
belt 3/16 inch (5 mm) at mid-span.
Form # 169018
PRE-DELIVERY CHECKS
I.
a. With the engine shut down and the header drive
b. With the engine shut down, do the following:
37
PERFORM SAFETY SYSTEM
CHECKS
CAUTION
Check to be sure all bystanders have cleared
the area.
A properly functioning system should operate as
follows:
•
The starter should engage ONLY when the
GSL is in N-DETENT, steering wheel locked
in the CENTER position, and the header
drive switch is in the OFF position.
•
Under the above conditions, the brake
should engage and the machine should not
move after engine start-up.
•
The steering wheel should not lock with the
engine running and the GSL is out of the N-
DETENT.
•
The machine should not move with the
engine running and with the steering wheel
still centered, when the GSL is pulled
straight out of N-DETENT (not in forward or
reverse).
If the system does not function as described
above, see your windrower dealer.
switch engaged, try to start the engine.
CDM will display "HEADER ENGAGED" on the
upper line, and "DISENGAGE HEADER' on the
lower line. If the engine turns over, the system
requires adjustment. See your dealer.
1. Open engine compartment hood.
2. Pry the steering interlock away from pintle
arms by inserting a wedge or pry bar
between one of the interlock channels and
pintle arm.
The
(continued next page)
Model Year - 2009