MacDon M150 Assembly Instructions Manual page 23

HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT – M200 STD, M150 OPTION
1. Re-locate the pin at the frame linkage as
required to position the hook over the
header pin.
HEADER
TILT DOWN
HEADER DOWN
2. Activate HEADER TILT cylinder switches on
GSL to extend or retract center link cylinder
so that the hook lines up with the header
attachment pin.
Form # 169018
UNLOADING AND ASSEMBLY
HEADER UP
HEADER TILT UP
3. Push down on rod end of link cylinder until
hook engages pin on header and is locked.
4. Check that center link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step e.
HYDRAULIC LINK
ALIGNMENT KIT
REEL DOWN
HEADER
TILT DOWN
1. Adjust the position of the center link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on
the GSL to position the hook above the
header attachment pin.
2. Lower the center link onto the header with
REEL DOWN switch, until it locks into
position (handle is down).
CAUTION
Check to be sure all bystanders have cleared
the area.
e. Start engine.
21
WITH OPTIONAL SELF-
REEL UP
HEADER TILT UP
(continued next page)
Model Year - 2009