Honda NC700 2012 Service Manual page 754

dummyhead dummyhead
2. Ground Line Open Circuit Inspection
Check for continuity between the 4P connector [1]
terminal and ground.
Connection: Green – Ground
Is there continuity?
YES
NO
3. Turn Signal/hazard Switch Line Open Circuit
Inspection
Connect the 4P connector [1] terminals with a
jumper wire.
Connection: Red/white – Gray
Operate the turn signal switch or push the hazard
switch.
Do the turn signal light illuminate?
YES
NO
4. Ignition Switch Power Source Line Open Circuit
Inspection
Turn the ignition switch ON.
Measure the voltage between the 4P connector [1]
terminal and ground.
Connection: Pink/blue (+) – Ground (–)
Is there battery voltage?
YES
NO
– GO TO STEP 3.
– Open circuit in the Green wire
– GO TO STEP 4.
– • Open circuit in the Gray wire
• Faulty turn signal switch or hazard
switch (left handlebar switch)
• Faulty turn signal light circuits
– System is normal, replace the turn signal/
hazard relay.
– • Open circuit in the Pink/blue wire
• Blown sub fuse 7.5 A (ILLUMI/STOP/
HORN)
LIGHTS/METERS/SWITCHES
[1]
G
[1]
Gr
R/W
[1]
P/Bu
22-31