Honda NC700 2012 Service Manual page 604

dummyhead dummyhead
INSTALLATION
Install the fork leg through the bottom bridge and top
Route the wires and
bridge while aligning top surface of fork pipe with the
cables properly
top surface of top bridge.
(page 1-25).
Tighten the bottom bridge pinch bolts [1] to the
specified torque.
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
If the fork cap [2] is loosened, tighten the fork cap to the
specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the top bridge pinch bolts [3] to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install the front brake caliper/bracket assembly [1] and
NC700XA/XD/SA/
tighten new brake caliper mounting bolts [2] to the
SD:
specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the following:
– Front fender (page 2-28)
– Front wheel (page 17-24)
STEERING STEM
REMOVAL
Remove the following:
NC700X/XA/XD:
– Shroud/side cover (page 2-14)
– Handlebar
– NC700X/XA (page 17-10)
– NC700XD (page 17-12)
Disconnect the ignition switch 2P (Brown) connector [1]
and immobilizer receiver 4P (Black) connector [2].
Release the each wire harness from the clamps [3].
FRONT WHEEL/SUSPENSION/STEERING
[2]
Align
[3]
NC700XA/XD/SA/SD:
[1]
NC700X/XA:
[3]
[1]
NC700XD: [3]
[1]
[1]
[2]
[3]
[2]
[3]
[2]
17-33