Honda NC700 2012 Service Manual page 633

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Drive the needle bearing [1] out of the left pivot using a
hydraulic press and special tool.
TOOLS:
Driver, 15 x 280L [2]
Pilot, 32 mm [3]
Remove the needle bearings [1] out of the shock
absorber bracket using the special tools.
TOOLS:
Bearing remover set, 17 mm [2] 07936-3710300
Remover handle [3]
Remover weight [4]
Apply molybdenum disulfide grease to a new needle
bearing rotating area.
Install the needle bearing [1] into the left pivot with the
marked side facing up to the specified range using a
hydraulic press and special tools as shown.
TOOLS:
Driver [2]
Attachment, 37 mm [3]
Pilot, 28 mm [4]
Apply grease to a new ball bearing rotating area.
Install the ball bearing [1] into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
Driver [2]
Attachment, 37 mm [3]
Pilot, 20 mm [4]
18-20
[2]
07949-3710001
07MAD-PR90200
[4]
07936-3710100
07741-0010201
[2]
07749-0010000
07ZMD-MBW0200
07746-0041100
[1]
07749-0010000
07ZMD-MBW0200
07746-0040500
[2] [1]
[3]
[3]/[4]
4.5 – 5.0 mm
(0.18 – 0.20 in)
[1]
[3]
[1]
[2]
[3]/[4]