Honda NC700 2012 Service Manual page 481

dummyhead dummyhead
ALTERNATOR/STARTER CLUTCH
SERVICE INFORMATION
GENERAL
• This section covers service of the alternator and starter clutch. All service can be done with the engine installed in the frame.
• For alternator inspection (page 21-9).
• For CKP sensor inspection (page 5-6).
• For starter motor service (page 6-8).
SPECIFICATIONS
Starter driven gear boss O.D.
Starter clutch outer I.D.
TORQUE VALUES
ITEM
Flywheel mounting bolt
Starter clutch socket bolt
Alternator stator mounting bolt
Alternator wire clamp bolt
TROUBLESHOOTING
Starter motor turns, but engine does not turn
• Faulty starter clutch
• Damaged starter reduction gear/shaft
• Damaged starter idle gear/shaft
• Damaged or faulty starter motor pinion gear
• Damaged starter driven gear
13-4
ITEM
THREAD
Q'TY
DIA. (mm)
1 12
6 8
4 6
1 6
STANDARD
57.749 – 57.768 (2.2736 – 2.2743)
74.412 – 74.442 (2.9296 – 2.9308)
TORQUE
N·m (kgf·m, lbf·ft)
157 (16.0, 116) Left hand thread
Apply engine oil to the threads and
seating surface.
30 (3.1, 22) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
10 (1.0, 7) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
10 (1.0, 7) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
Unit: mm (in)
SERVICE LIMIT
57.73 (2.273)
74.46 (2.931)
REMARKS