Honda NC700 2012 Service Manual page 734

dummyhead dummyhead
GROUND LINE
Check for continuity at the combination meter 16P
(Gray) connector [1] of the wire harness side and
ground.
CONNECTION: Green/red – Ground
There should be continuity.
If there is no continuity, check for open circuit in Green/
red wire.
TXD/RXD LINE INSPECTION
NC700X/XA/S/SA
If the MIL [1] and engine oil pressure indicator [2] are
stay on and tachometer, high coolant temperature
indicator and HISS indicator does not come on with the
ignition switch turned ON and engine stop switch " ",
check the combination meter TXD/RXD line (page 22-
12).
If the engine stop switch turned " ", the combination
meter indicate same operation.
NC700XD/SD
Turn the ignition switch ON with the engine stop switch
" " and check the combination meter.
The TXD/RXD line is abnormal if the combination meter
shows following:
– MIL [1] and engine oil pressure indicator [2] stay on.
– Shift indicator "–" [3] is blinking.
– Tachometer, high coolant temperature indicator and
HISS indicator do not come on.
If the ignition switch is turned ON with the engine stop
switch turned " ", the same condition will occur.
Check the combination meter TXD/RXD line (page 22-
12).
LIGHTS/METERS/SWITCHES
[1]
[1]
[1]
G/R
[2]
[2]
[3]
22-11