Honda NC700 2012 Service Manual page 506

dummyhead dummyhead
INSTALLATION
MAINSHAFT/COUNTERSHAFT
Install the mainshaft assembly [1] into the upper
crankcase.
Apply engine oil to the right mainshaft bearing [1].
Install the right mainshaft bearing into the upper
crankcase.
Install the bearing into the crankcase with the marked
side facing out.
Apply locking agent to the mainshaft bearing set plate
bolts threads (page 14-6).
Install the mainshaft bearing set plate [1] with its "OUT
SIDE" mark [2] facing out.
Install and tighten the mainshaft bearing set plate bolts
[3] to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the dowel pin [1] onto the upper crankcase hole.
Install the countershaft bearing set ring [2] to the
countershaft bearing groove.
Install the countershaft assembly [3].
• Align the needle bearing cap hole with the dowel pin.
• Align the set ring with the upper crankcase groove.
Install the shift drum/shift fork (page 14-16).
Assemble the crankcase (page 14-28).
CRANKCASE/TRANSMISSION/BALANCER
[2]
[1]
[1]
[2] [1]
[3]
[3]
[1]
14-15