Honda NC700 2012 Service Manual page 438

dummyhead dummyhead
4. Outer Mainshaft Sensor Ground Line Open
Circuit Inspection
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
test harness [2] terminals.
Connection: Green/yellow – B22
Is there continuity?
YES
NO
5. Outer Mainshaft Output Line Open Circuit
Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
test harness [2] terminals.
Connection: Pink/yellow – A21
Is there continuity?
YES
NO
6. Outer Mainshaft Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1]
terminal and ground.
Connection: Pink/yellow – Ground
Is there continuity?
YES
NO
7. Outer Mainshaft Sensor Inspection
Replace the outer mainshaft sensor with a known
good one (page 12-115).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and read the DTC with the
shift indicator (page 12-13).
Is DTC 54 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the Green/yellow wire
– GO TO STEP 6.
– Open circuit in the Pink/yellow wire
– Short circuit in the Pink/yellow wire
– GO TO STEP 7.
– Replace the PCM sensor with a new one,
and recheck.
– Faulty original outer mainshaft sensor
[1]
G/Y
[2]
A21
[1]
[2]
B22
P/Y
[1]
P/Y
12-83