Honda NC700 2012 Service Manual page 732

dummyhead dummyhead
SYSTEM INSPECTION (NC700XD/SD)
Check for loose or poor contact terminals at the
combination meter 16P (Gray) connector.
When the ignition switch is turned ON with the engine
stop switch " ", the combination meter will show the
entire digital display and the tachometer segments [1]
will reduce from full scale to zero.
If the tachometer segment does not show initial
function, check the combination meter power input line
(page 22-10).
If the power and ground lines are OK, replace the
combination meter assembly.
– NC700XD (page 22-9)
– NC700SD (page 22-9)
If the MIL and engine oil pressure indicator are stay on
and tachometer, high coolant temperature indicator and
HISS indicator does not come on, inspect the following;
– DTC with the HDS (page 4-12)
– TXD/RXD line (page 22-11)
REMOVAL/INSTALLATION (NC700X/
XA/XD)
Remove the windscreen (page 2-23).
Remove the dust cover [1].
Disconnect
connector [2].
Remove the screws [3], washer [4] and combination
meter [5].
Installation is in the reverse order of removal.
TORQUE:
Combination meter mounting screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
REMOVAL/INSTALLATION (NC700S/
SA/SD)
Remove the headlight/headlight stay (page 2-27).
Remove the combination meter back cover mounting
screws [1] and combination meter back cover [2].
the combination meter
LIGHTS/METERS/SWITCHES
[2]
16P (Gray)
[3]/[4]
[1]
[1]
[5]
[1]
[2]
22-9