Table of Contents
Advertisement
dummyhead
dummyhead
FUEL SYSTEM
FUEL TANK
REMOVAL/INSTALLATION
Relieve the fuel pressure (page 7-4).
Remove the bolts [1], fuel cap [2] and fuel cap tray [3].
Release the following:
– Fuel tank drain hose A [4]
– Fuel tank breather hose [5]
– Seat lock cable [6]
Remove the fuel tank mounting bolts [7], washers [8],
upper mounting rubbers [9], lower mounting rubbers
[10] and collars [11].
Lift the rear end of the fuel tank and disconnect the
following:
– Fuel pump unit 3P (Black) connector [12]
– Quick connect fitting (page 7-8)
Do not bend or twist fuel feed hose.
Remove the fuel tank [13].
Installation is in the reverse order of removal.
• Connect the quick connect fitting (page 7-9).
• Route the hose and wire properly (page 1-25).
FUEL PUMP SIDE QUICK CONNECT FITTING
REMOVAL
1. Relieve the fuel pressure (page 7-4).
2. Check the fuel quick connect fitting [1] for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
3. Pull and release the joint rubber [1] from the
retainer.
4. Hold the connector with one hand and squeeze the
retainer tabs [2] with the other hand to release them
from the locking pawls [3].
Pull the connector off and remove the retainer.
• Absorb the remaining fuel in the fuel feed hose from
flowing out with a shop towel.
• Be careful not to damage the hose or other parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it comes off easily.
7-8
[4]
[1]
[3]
[6]
[13]
[1]
[1]
[2]
[3]
[1]
[7]
[5]
[8]
[9]
[10]
[11]
[2]
[12]
Hide quick links:
Advertisement
Table of Contents
