Honda NC700 2012 Service Manual page 335

dummyhead dummyhead
CYLINDER HEAD/VALVES
Apply engine oil to a new O-ring [1] and install it to the
camshaft maintenance cap [2].
Temporarily Install the camshaft maintenance cap to
the cylinder head.
If the engine is removed from the frame, tighten the
camshaft maintenance cap to the specified torque.
TORQUE: 4.0 N·m (0.4 kgf·m, 3.0 lbf·ft)
If the engine is installed on the frame, insert a feeler
gauge (0.1 mm) [1] between the camshaft maintenance
cap and cylinder head.
Tighten the camshaft maintenance cap securely.
Remove the feeler gauge.
Further tighten the camshaft maintenance cap at 30°.
One concave area [2] size is equivalent with 30°.
Install the following:
– Cylinder head cover (page 10-5)
– Right crankcase cover
– NC700X/XA/S/SA (page 11-5)
– NC700XD/SD (page 12-103)
– Engine
– NC700X/XA/S/SA (page 16-15)
– NC700XD/SD (page 16-21)
10-28
[2]
[1]
[1]
[2]