Honda NC700 2012 Service Manual page 341

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
Remove the dowel pins [1].
Clean off any sealant from the right crankcase cover
mating surfaces.
Installation is in the reverse order of removal.
• Apply liquid sealant (Three bond 1207B or
equivalent) to the right crankcase cover mating
surface as shown.
• Do not apply more liquid sealant than necessary.
• Apply liquid sealant (Three bond 1207B or
equivalent) to the CKP sensor wire grommet sealing
surface.
• Replace the sealing washer with a new one.
• Route the cables and wire harness properly (page 1-
25).
Adjust the clutch lever freeplay (page 3-26).
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
CLUTCH LIFTER ARM REMOVAL/
INSTALLATION
Remove the clutch lifter rod A [1].
Remove the snap ring [2], clutch lifter arm [3] and return
spring [4] from the right crankcase cover.
Check the return spring for fatigue or damage.
Check the lifter arm spindle [1] for wear or damage.
Check the lifter arm oil seal [2] and needle bearings [3]
for wear or damage.
11-6
[1]
[2]
[3] [1]
[1]
[3]
[4] [1]
[2]