Honda NC700 2012 Service Manual page 620

dummyhead dummyhead
INSPECTION
WHEEL RIM
Check the rim runout by placing the wheel in a truing
stand.
Spin the wheel by hand, and measure the runout using
a dial indicator.
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:
AXLE
Place the axle on V-blocks.
Turn the axle and measure the runout using a dial
indicator.
Actual runout is 1/2 of the total indicator reading.
SERVICE LIMIT: 0.2 mm (0.01 in)
WHEEL AND DRIVEN FLANGE BEARINGS
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the outer race fits tightly in the wheel
hub and driven flange.
Remove and discard the bearings if the races do not
Replace the
turn smoothly, quietly, or if they fit loosely in the wheel
bearings as a set.
hub and driven flange.
WHEEL BALANCE
For wheel balance servicing (page 17-22).
DRIVEN SPROCKET
For driven sprocket inspection (page 3-18).
DISASSEMBLY
Loosen the rear brake disc mounting bolts [1] in a
crisscross pattern in 2 or 3 steps.
Remove the rear brake disc mounting bolts, brake disc
[2] and pulser ring (NC700XA/XD/SA/SD) [3].
Remove the dust seal [4] from the right wheel hub.
2.0 mm (0.08 in)
REAR WHEEL/SUSPENSION
NC700XA/XD/SA/SD shown:
[3]
[2]
[1]
[4]
18-7