Honda NC700 2012 Service Manual page 333

dummyhead dummyhead
CYLINDER HEAD/VALVES
Install the cam chain guide [1].
• Align the cam chain guide end with the groove in the
crankcase.
• Align the cam chain guide tabs with the grooves in
the crankcase.
Install the dowel pins [1] and new gasket [2].
Route the cam chain through the cylinder head and
install the cylinder head [1] onto the cylinder.
Apply molybdenum oil solution to the cylinder head
special bolts [2] threads and seating surface.
Install and tighten the cylinder head special bolts in a
crisscross pattern in 2 or 3 steps to the specified torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
Install and tighten the 6 mm bolts [1].
10-26
[1]
[2]
[1]
Align
Align
[2]
[1]
[1]