Honda NC700 2012 Service Manual page 301

dummyhead dummyhead
LUBRICATION SYSTEM
OIL PRESSURE INSPECTION
Remove the following:
– Lower cowl (page 2-28)
– Engine oil filter cartridge (page 3-13)
Apply engine oil to the O-ring and install the oil pressure
attachment [1] onto the oil filter boss.
TOOL:
Oil pressure gauge attachment
Apply engine oil to the O-ring and install the engine oil
filter cartridge [2] onto the oil pressure attachment.
TOOL:
Oil filter wrench
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Connect the oil pressure gauge [3] and attachment [4]
to the oil pressure gauge attachment.
TOOLS:
Oil pressure gauge set
Oil pressure gauge attachment
Fill the engine with the recommended engine oil (page
3-12).
Warm the engine to normal operating temperature
(approximately 80°C/176°F) and increase the engine
speed to 6,000 min
STANDARD:
470 kPa (4.8 kgf/cm
(80°C/176°F)
Stop the engine and remove the tools.
Install the following:
– Engine oil filter cartridge (page 3-13)
– Lower cowl (page 2-28)
OIL PUMP (NC700X/XA/S/SA)
REMOVAL/INSTALLATION
Remove the right crankcase cover (page 11-5).
Remove the bolts [1] and oil pump [2].
9-6
070MJ-0010101
07HAA-PJ70101
07506-3000001 or
equivalent
commercially
available
07406-0030000 or
equivalent
commercially
available
-1
(rpm) and read the oil pressure.
2 -1
, 68 psi) at 5,000 min (rpm)/
[3] [1]
[1]
[2]
[4]
[2]