Table of Contents
Advertisement
dummyhead
dummyhead
Install the muffler, then loosely install the muffler
mounting bolt, washer, nut and band bolt (page 2-32).
Tighten the exhaust pipe joint nuts [1] to the specified
torque in numerical order by stamped number on the
exhaust pipe joint [2] in 2 or 3 steps.
TORQUE: 28 N·m (2.9 kgf·m, 21 lbf·ft)
Tighten the exhaust pipe mounting nut [1] securely.
Tighten the ground wire mounting bolt [2] securely.
Install the O
reserve tank guide [2].
Route the O
Connect the O
Tighten the muffler mounting nut and band bolt securely
(page 2-32).
Install the lower cowl (page 2-28).
STUD BOLT REPLACEMENT
Remove the exhaust pipe/muffler (page 2-32).
Thread two nuts onto the stud and tighten them
together, and use a wrench on them to turn the stud bolt
out.
Install new stud bolts into the cylinder head as shown.
After installing the stud bolts, check that the length from
the bolt head to the cylinder head surface is within
specification.
Install the exhaust pipe/muffler (page 2-32).
sensor wire to the clamp [1] and radiator
2
sensor wire properly (page 1-25).
2
sensor 1P (Black) connector [3].
2
FRAME/BODY PANELS/EXHAUST SYSTEM
[3]
30.0 – 31.0 mm
(1.18 – 1.22 in)
[1]
[2]
[2]
[1]
[1]
[2]
2-35
Hide quick links:
Advertisement
Table of Contents
