Honda NC700 2012 Service Manual page 13

dummyhead dummyhead
GENERAL INFORMATION
PGM-FI SPECIFICATIONS
IAT sensor resistance (at 20°C/68°F)
ECT sensor resistance (at 40°C/104°F)
Injector resistance (at 20°C/68°F)
IGNITION SYSTEM SPECIFICATIONS
Spark plug (Iridium)
Spark plug gap
Ignition coil peak voltage
CKP sensor peak voltage (at 20°C/68°F)
Ignition timing ("F" mark)
ELECTRIC STARTER SPECIFICATION
Starter motor brush length
FUEL SYSTEM SPECIFICATIONS
Throttle body identification number
Idle speed
Throttle grip freeplay
Fuel pressure at idle
Fuel pump flow (at 12 V)
COOLING SYSTEM SPECIFICATIONS
Coolant capacity
Radiator cap relief pressure
Thermostat
Recommended antifreeze
Standard coolant concentration
1-8
ITEM
ITEM
ITEM
ITEM
ITEM
Radiator and engine
At draining
Reserve tank
Begin to open
Fully open
Valve lift
SPECIFICATIONS
2.2 – 2.7 kΩ
1.0 – 1.3 kΩ
11 – 13 Ω
SPECIFICATIONS
IFR6G-11K (NGK)
1.0 – 1.1 mm (0.039 – 0.043 in)
100 V minimum
0.7 V minimum
12° BTDC at idle
STANDARD
12.0 – 13.0 (0.47 – 0.51)
SPECIFICATIONS
GQ3UA
1,200 ± 100 min
2 – 6 mm (1/16 – 1/4 in)
343 kPa (3.5 kgf/cm
3
230 cm (7.8 US oz, 8.1 Imp oz) minimum/10 seconds
SPECIFICATIONS
1.69 liters (1.79 US qt, 1.49 Imp qt)
1.41 liters (1.49 US qt, 1.24 Imp qt)
0.13 liter (0.14 US qt, 0.11 Imp qt)
108 – 137 kPa (1.1 – 1.4 kgf/cm
80 – 84°C (176 – 183°F)
95°C (203°F)
8 mm (0.3 in) minimum
High quality ethylene glycol antifreeze containing silicate-free
corrosion inhibitors
1:1 (mixture with distilled water)
Unit: mm (in)
SERVICE LIMIT
6.5 (0.26)
-1
(rpm)
2
, 50 psi)
2
, 16 – 20 psi)