Honda NC700 2012 Service Manual page 192

dummyhead dummyhead
3. VS Sensor Input Voltage Inspection
Turn the ignition switch OFF.
Disconnect the VS sensor 3P (Black) connector [1].
Turn the ignition switch ON.
Measure the voltage at the VS sensor 3P (Black)
connector of the wire harness side.
Connection: Pink/blue (+) – Green/red (–)
Standard:
Is there battery voltage?
YES
NO
4. VS Sensor Signal Line Short Circuit Inspection
Turn the ignition switch OFF.
Check for continuity between the VS sensor 3P
(Black) connector [1] of the wire harness side and
ground.
Connection: Pink/green – Ground
Is there continuity?
YES
NO
5. VS Sensor Signal Line Open Circuit Inspection
NC700X/XA/S/SA:
Disconnect the combination meter 16P (Gray)
connector [1].
Check for continuity between the VS sensor 3P
(Black) connector [2] and combination meter 16P
(Gray) connector of the wire harness side.
Connection: Pink/green – Pink/green
NC700XD/SD:
Disconnect the PCM 33P (Gray) connector [3].
Check for continuity between the VS sensor 3P
(Black) connector [4] and PCM 33P (Gray)
connector of the wire harness side.
Connection: Pink/green – Pink/green
TOOL:
Test probe
Is there continuity?
YES
NO
Battery voltage
– GO TO STEP 4.
– • Open circuit in the Pink/blue wire
• Open circuit in the Green/red wire
– Short circuit in the Pink/green wire
– GO TO STEP 5.
07ZAJ-RDJA110
– GO TO STEP 6.
– Open circuit in the Pink/green wire
PGM-FI SYSTEM
P/Bu
NC700X/XA/S/SA:
[2]
P/G
NC700XD/SD:
[3]
P/G
[1]
G/R
[1]
P/G
[1]
P/G
[4]
P/G
4-31