Honda NC700 2012 Service Manual page 542

dummyhead dummyhead
Apply engine oil to the piston pin outer surface.
Adjust the length of the insert pin [1] and insert adjuster
[2] to 44.0 mm (1.73 in).
TOOLS:
Piston pin tool set
– Insert pin
– Insert adjuster
Insert the pilot collar [3] into the piston [4] and
connecting rod [5].
TOOL:
Piston pin tool set
– Pilot collar, 18 mm
Place the piston, connecting rod and pilot collar on the
special tools.
TOOLS:
Piston pin tool set [6]
– Piston base head insert
– Piston base head
– Piston pin pilot
– Piston base spring
– Piston base
Be sure to position the piston flat area against the
piston base head inserts as shown.
Place the piston pin [7], insert pin/insert adjuster on the
pilot collar.
Place the piston [1], connecting rod [2], piston pin [3]
and special tools on the hydraulic press.
Press the piston pin until special tools fully seated.
CRANKSHAFT/PISTON/CYLINDER
[4]
[5]
07PAF-0010000
07PAF-0010700
07PAF-0010800
07PAF-0010000
07PAF-0010640
[3]
07PAF-0010000
07PAF-0010500
07PAF-0010400
07PAF-0010300
07973-6570600
[6]
07973-6570500
[3]
[1]
[1]/[2]
44.0 mm
(1.73 in)
[7]
[2]
15-19