Honda NC700 2012 Service Manual page 739

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
SPEEDOMETER/VS SENSOR
SYSTEM INSPECTION (NC700X/XA/S/
SA)
Perform the combination meter system inspection
(page 22-8).
Remove the windscreen (page 2-23).
Remove the dust cover [1].
If the system fails the inspection, shift the transmission
into neutral, the combination meter 16P (Gray)
connector [2] is connected, then turn the ignition switch
ON.
Measure the voltage at the combination meter 16P
(Gray) connector [1] of the wire harness side.
CONNECTION: Pink/green (+) – Green/red (–)
STANDARD:
Slowly turn the rear wheel by hand.
There should be 0 to 5 V pulse voltage.
– If pulse voltage appears, replace the combination
meter assembly.
– NC700X/XA (page 22-9)
– NC700S/SA (page 22-9)
– If pulse voltage does not appear, check for open or
short circuit in Pink/green wire.
If the Pink/green wire is OK, check for the VS sensor
signal line (page 22-17)
SYSTEM INSPECTION (NC700XD/SD)
If the speedometer does not operate, check the
following:
– Combination meter system inspection (page 22-9)
– MIL blinking: If the MIL blinks 11, check the VS
sensor system (page 4-51)
– Shift indicator "–" blinking: If the shift indicator "–"
blinks 66, check the VS sensor system (page 12-
89).
If the above items are OK, check the VS sensor line as
follows:
Remove the windscreen (page 2-23).
Remove the dust cover [1] and disconnect the
combination meter 16P (Gray) connector [2].
22-16
Repeat 0 to 5 V
NC700X/XA: [2] NC700S/SA:
[1]
[1]
P/G
NC700XD: [2] NC700SD:
[1]
[2]
[1]
G/R
[2]
[1]