Honda NC700 2012 Service Manual page 538

dummyhead dummyhead
Clean carbon deposits from the piston ring grooves with
Never use a wire
a ring that will be discarded.
brush; it will scratch
the groove.
PISTON REMOVAL
Assemble the special tools as shown.
TOOLS:
Piston pin tool set
– Piston base head [1]
– Piston pin pilot [2]
– Piston base spring [3]
– Piston base [4]
Temporarily install the pilot collar [1] to the piston pin
pilot, and adjust the piston base head inserts [2] as
shown, then tighten the screws [3].
TOOLS:
Piston pin tool set
– Piston base head insert
– Pilot collar, 18 mm
Remove the pilot collar.
Assemble and adjust the length of the insert pin [1] and
insert adjuster [2] to 44.0 mm (1.73 in).
TOOLS:
Piston pin tool set
– Insert pin
– Insert adjuster
CRANKSHAFT/PISTON/CYLINDER
[1]
07PAF-0010000
07PAF-0010400
07PAF-0010300
07973-6570600
07973-6570500
[4]
[1]
[2]
07PAF-0010000
07PAF-0010500
07PAF-0010640
[3]
07PAF-0010000
07PAF-0010700
07PAF-0010800
[1]
[2]
[3]
[2] [1] [2]
[3] [3]
1.0 mm (0.04 in)
44.0 mm (1.73 in)
[2]
15-15