Honda NC700 2012 Service Manual page 247

dummyhead dummyhead
ELECTRIC STARTER
SERVICE INFORMATION
GENERAL
If the current is kept flowing through the starter motor turn it while the engine is not cranking over, the starter motor may be
damaged.
• The starter motor can be serviced with the engine installed in the frame.
• Always turn the ignition switch OFF before servicing the starter motor. The motor could suddenly start, causing serious injury.
• A weak battery may be unable to turn the starter motor quickly enough, or supply adequate ignition current.
• When servicing the starter system, always follow the steps in the troubleshooting flow chart (page 6-5).
• Refer to the following components information:
– Ignition switch (page 22-24)
– Starter switch (page 22-25)
– Engine stop switch (page 22-25)
– Neutral switch (NC700X/XA/S/SA) (page 22-27)
– Sidestand switch (NC700X/XA/S/SA) (page 22-28)
– Clutch switch (NC700X/XA/S/SA) (page 22-26)
SPECIFICATION
Starter motor brush length
TORQUE VALUE
ITEM
Starter motor terminal nut
6-4
ITEM
THREAD
Q'TY
DIA. (mm)
1 6
STANDARD
12.0 – 13.0 (0.47 – 0.51)
TORQUE
N·m (kgf·m, lbf·ft)
10 (1.0, 7)
Unit: mm (in)
SERVICE LIMIT
6.5 (0.26)
REMARKS