Table of Contents
Advertisement
dummyhead
dummyhead
HYDRAULIC BRAKE
Unhook the brake light switch spring [1].
Remove the brake light switch [2] from the right step
holder [3], then remove the right step holder.
Remove and discard the cotter pin [1].
Remove the joint pin [2] and disconnect the push rod
joint from the brake pedal.
Remove the master cylinder mounting bolts [3] and
master cylinder [4] from the right step holder.
Installation is in the reverse order of removal.
• Replace the cotter pin and sealing washers with new
ones.
• Install the brake hose eyelet joint against the master
cylinder stopper.
TORQUE:
Rear master cylinder mounting bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Step holder mounting socket bolt:
32 N·m (3.3 kgf·m, 24 lbf·ft)
Brake hose oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill the reservoir to the upper level and bleed the rear
brake system:
– NC700X/S (page 19-9)
– NC700XA/XD/SA/SD (page 19-12)
19-24
[3]
[1]
[2]
[2]
[1]
[4]
[3]
Hide quick links:
Advertisement
Table of Contents
