Honda NC700 2012 Service Manual page 105

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
REAR FENDER MUD GUARD (U type)
REMOVAL/INSTALLATION
Remove the screw [1], socket bolts [2] and rear fender
mud guard [3].
BRAKE/TAIL/LICENSE LIGHT/TAIL LIGHT COVER
REMOVAL/INSTALLATION
Remove the rear fender mud guard (U type) (page 2-
10).
Remove the screw [1] and open the cover [2].
Disconnect the following:
– Rear right turn signal light 2P (Light blue) connector
[3]
– Rear left turn signal light 2P (Orange) connector [4]
– Brake/tail/license light 3P connector [5]
Remove the brake/tail/license light mounting socket bolt
[1] and collar [2].
Remove the socket bolts (E, ED, F, KO, RU type) [3]
and brake/tail/license light assembly [4] and release the
wire harnesses from the rear fender A.
Installation is in the reverse order of removal.
Route the wire harness properly (page 1-25).
TORQUE:
Brake/tail/license light mounting socket bolt:
10 N·m (1.0 kgf·m, 7 lbf·ft)
2-10
[1] [3] [2]
E, ED, F, KO, RU type shown:
[2] [1]
E, ED, F, KO, RU type shown:
[4]
[3]/[4]/[5]
[1]
[2]
[3]