Table of Contents
Advertisement
Oracle ILOM System Console
Note -
emulator (PC or workstation) connected to the SP SER MGT port, you will not see system
messages.
(Optional) Connect an Ethernet cable between the server's NET MGT port and
4.
the network to which future connections to the SP and host will be made.
Configure the system for the first time through the SER MGT port. After the initial
configuration, you can set up communication between the SP and host through this Ethernet
interface.
5.
Connect an Ethernet cable between one of the server's NET ports and the
network to which the server will communicate.
6.
Connect the power cords to the power supplies and to separate power sources.
When the power cords are connected, the SP initializes and the power supply LEDs illuminate.
After a few minutes, the SP login prompt is displayed on the terminal device. At this time, the
host is not initialized or powered on.
Continue with the installation by powering on the server for the first time.
7.
See
"Powering On the Server for the First Time" on page
Related Information
"Connect the SER MGT Cable" on page 58
■
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 72
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 74
■
Oracle ILOM System Console
When you power on the server, the boot process begins under the control of the Oracle ILOM
system console. The system console displays status and error messages generated by firmware-
based tests that are run during system startup.
Note -
SER MGT before applying power to the server. See
SER MGT Port" on page 67
68
SPARC T7-1 Server Installation Guide • October 2015
If you power on the server for the first time and do not have a terminal or terminal
To see these status and error messages, connect a terminal or terminal emulator to the
65.
"Connect a Terminal or Emulator to the
Advertisement
Table of Contents
