Oracle Ilom System Console; Installing The Os - Oracle SPARC T7-4 Installation Manual

Oracle ILOM System Console

Oracle ILOM System Console
When power is first applied to the system, the boot process begins under the control of the
Oracle ILOM system console. The system console displays status and error messages generated
by firmware-based tests that are run during system startup.
Note -
SER MGT before applying power to the server.
After the system console finishes its low-level system diagnostics, the SP initializes and runs a
suite of higher level diagnostics. When you access the SP using a device connected to the SER
MGT port, you see the output of the Oracle ILOM diagnostics.
By default, the SP configures the NET MGT port automatically, retrieving network
configuration settings using DHCP and allowing connections using SSH.
For a more detailed discussion on configuring the system console and connecting terminals,
refer to the administration guide for your server.
Related Information
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 73
■
"Assign a Static IP Address to the NET MGT Port" on page 78
■
SPARC T7 Series Servers Administration Guide
■
Oracle ILOM documentation
■

Installing the OS

Use these topics to either configure the preinstalled OS or use an alternative OS.
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 73
■
Related Information
"Oracle Solaris OS Configuration Parameters" on page 75
■
70 SPARC T7-4 Server Installation Guide • March 2017
To see these status and error messages, connect a terminal or terminal emulator to the