Program 16 : Department Group Setup; Department Group Basic Data Setup - NEC SL2100 Programming Manual

ISSUE 2.0

Program 16 : Department Group Setup

Level:
IN
Description
Use Program 16-01 : Department Group Basic Data Setup to set the function mode for each
department group. There are 50 available Department Groups.
Input Data
Department Group Number
Item Item
No.
01 Department
Name
02 Department Call-
ing Cycle
03 Department
Routing when
Busy (Auto Step
Call)
04 Hunting Mode
05 Extension Group
All Ring Mode
Operation
06 STG Withdraw
Mode
07 Call Recall Re-
striction for STG
Programming Manual

16-01 : Department Group Basic Data Setup

Input Data
Maximum 12 charac- This program is used to assign a
ters name to the department group.
0 = Normal Routing Use this option to set the call routing
(Priority) for Department Calling. Routing can
1 = Easy - UCD Rout- be either circular (cycles to all
ing (Circular) phones in group) or priority (cycles
to highest priority extensions first).
0 = Normal (Intercom Set this option to set how the sys-
caller hears busy tone.) tem routes an Intercom call to a
1 = Circular (Intercom busy Department Group member.
caller routes to an idle Intercom callers to the extension
group member.) can either hear busy or route to the
first available department number.
This only occurs for calls to the ex-
tension directly, not the department
number assigned in Program 11-07.
0 = Stop at last mem- Use this option to set the action tak-
ber (non-loop) en when a call reaches the last ex-
1 = Circular tension in the Department Group (0
= hunting stopped, 1 = hunting re-
peats with circular routing through
the Department Group).
0 = Manual (Ring the Determine whether calls ringing a
extensions one at a Department Group should ring all
time when the service extensions in the group simultane-
code are pressed.) ously automatically or manually
1 = Automatic (Ring all when using the service code defined
extensions.) in Program 11-12-09.
0 = Disabled (Call will
camp on to the group.)
1 = Automatic (Call fol-
lows PRG 22-11-11.)
0 = Disabled (Call will Determine whether or not an unan-
recall.) swered call transferred to a Depart-
1 = Enabled (Call will ment Group should recall the exten-
not recall.) sion from which it was transferred.
1 ~ 50
Description
When set to (1) Automatic, only
ICM Calls and DID Calls will
ring all the stations in the De-
partment Group.
SL2100
Default Related
Program
No Setting 11-07
0 16-02
0 16-02
0 16-02
0 11-16-10
0
0 24-02-04
2-175
Program
16