NEC SL2100 Programming Manual page 401

ISSUE 2.0
Item Item
No.
04 Route Table Set-
up of Target Dial
05 ANI/DNIS Display
as Target Dial
Name
06 Routing SPD Ta-
ble Setup
07 Routing on ANI/
DNIS Error
08 Routing When
Destination Busy
or No Answer
Programming Manual
Input Data
0 = ABB Table The option sets how the system
(Program 13-03) uses the route data (gathered in
1 = DDI Table Item 3) to route incoming ANI/DNIS
(Program 22-11) calls.
If option 2 is selected, and the call is
to be routed using the DID table (1),
up to eight digits can be matched.
The number of expected digits set in
Program 22-09-01 must match the
ANI digits defined in Program
22-11-01. For example, if an ANI/
DNIS number received was
2035551234
*
22-09- 01 = 4, the entry in 22-11-01
must be 1234 with the defined target
extension.
If the call is to be routed using the
ABB table (0), up to 36 digits can be
matched. Define the range of the
ABB table to be used in Program
34-09-06. The data is compared to
the entries in Program 13-04-01 and
then routed according to Program
13-04-03.
0 = Display Off Use this option to set whether or not
1 = Display On ANI data should appear on tele-
phone displays as part of Caller ID
display.
Start = 0, 100 ~ 900 Use this option to define which part
End = 0, 99 ~ 999 of the ABB Table set up in Program
13-04 the system uses for ANI/DNIS
Caller ID look-ups and ANI/DNIS
routing.
This is required if Items 4 and 5
above are 1 (Caller ID on). When
you specify a starting and end ad-
dress, the system uses the part of
the table for look-ups.
When you specify a starting address
and length, the system uses that
part of the table for routing. If the in-
coming ANI/DNIS number data
matches the Number entry in the ta-
ble, the system routes according to
the associated Name data. That da-
ta can be an extension, Department
Group pilot number, the voice mail
master number or a trunk ring
group.
0 = Play Busy Tone to This option lets you determine how
Caller the system handles an ANI/DNIS
1 = Route Caller to call if a data error is detected in the
Ring Group Specified incoming data string.
in Program 25-03
(Transfer)
0 = Play Busy or Ring- This option lets you determine how
back Tone to Caller the system handles an ANI/DNIS
(Busy/ NoAns) call if destination is busy or does not
1 = Route Caller to answer.
Ring Group Specified
in Program 25-04
(Transfer)
Description Default
COS 1 = 0
COS 2 ~ 15 = 0
3001 and Program
* *
COS 1 = 1
COS 2 ~ 15 = 0
COS 1 =
Start = 900
End = 999
COS 2 ~ 15 =
Start = 0
COS 1 = 1
COS 2 ~ 15 = 0
COS 1 = 0
COS 2 ~ 15 = 0
SL2100
Related
Program
13-04
22-11-03
34-09-05
13-04
20-09-02
22-11-03
23-09-04
13-04
End = 0
25-03
25-04
2-377
Program
34