Dial Analysis Table For Ars/F-Route Access - NEC SL2100 Programming Manual

ISSUE 2.0

44-02 : Dial Analysis Table for ARS/F-Route Access

Level:
IN
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction Table
for selecting ARS/F-Route.
Input Data
Dial Analysis Table Number
Item Item
No.
01 Dial
02 Service Type
Programming Manual
Program 44 : ARS/F-Route Setup
Input Data
Up to eight digits Set the number of digits to be ana-
(Use line key 1 for a lyzed by the system for ARS routing.
Don't Care digit, @)
0 = No Setting (None) • Service Type 1 (Extension Num-
1 = Extension Call ber)
(Own) The number goes to an extension
2 = ARS/F-Route Table after deleting the front digit(s).
(F-Route) Additional Data
3 = Dial Extension Ana- Assign the digit(s) to be deleted
lyze Table (Option) on top of the number for exten-
sion number usage. At least one
digit must be deleted.
• Service Type 2 (ARS/F-Route)
The number is controlled by
ARS/F-Route table.
Additional Data:
If the ARS/F-Route Time Sched-
ule is not used, assign the ARS/F-
Route table number for Program
44-05.
If the ARS/F-Route Time Sched-
ule is used, assign the ARS/F-
Route selection number for Pro-
gram 44-04.
• Service Type 3 (Dial Extension
Analyze Table)
The total length of the number ex-
ceeds more than 8 digits.
Additional Data:
Assign the Dial Extension Analy-
sis Table number to be used in
Program 44-03.
1 ~ 200
Description Default
No Setting
SL2100
Program
44
Related
Program
0 44-02-01
44-03
44-05
2-425