Section 2 Start-Up Programming (Default) - NEC univerge sv8100 User Manual

47-02 InMail Station Mailbox Options
Description
Use 47-02 InMail Station Mailbox Options to set up a station (extension) mailbox.
Station mailboxes are automatically assigned as Subscriber Mailboxes. You can also
set up Group Mailboxes as Subscriber Mailboxes.
Typically, InMail Station Mailbox numbers 1~26 correspond to extensions 200~225.
There are three Station Mailbox categories:
.
.
Options
InMail System Guide
Undefined
Station
Group
Refer to Group (Shared) Mailbox on page 2-181
Be aware that mailboxes beginning with a leading digit of either 0, * and # are not supported.
47-02-01 Mailbox Type
Use this option to enable or disable the mailbox. An extension mailbox is
not accessible when it is disabled (even though stored messages and
configuration are retained in memory.) If disabled, a user pressing Message
will initiate a remote logon and be asked to enter their mailbox number. A
voice prompt then announces: "That mailbox does not exist."
To make programming easier, consider associating a mailbox number with
a station port.
For example, mailbox 1 could correspond to port 1, which in turn
corresponds to extension 101.
See
.
See
.
Options
0 (Undefined)
1 (Personal)
2 (Group)
Default
Mailboxes 1~64 = 1 (Personal)
and

Section 2 Start-Up Programming (Default)

Subscriber Mailbox on page 2-337
Station Mailbox on page 2-335.
for more.
for more.
Issue 7.00
3 - 393